[Wireless Lan] - Panasonic PT-VW345NZ Operating Instructions Manual

4) Press as to select [OK], and press the <ENTER> button.
r Default wired LAN settings
f The following settings are set before the projector leaves the factory.
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f Consult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.
f A wired LAN and wireless LAN cannot be used in the same segment.

[WIRELESS LAN]

Set the connections of wireless LAN.
1) Press as to select [WIRELESS LAN].
2) Press qw to select the connection method.
[DISABLE]
[S-DIRECT]
[M-DIRECT]
[USER1]/[USER2]/[USER3]
Attention
f If you want to use the 5.2 GHz / 5.3 GHz band of IEEE802.11a, please do not use it outdoors. The outdoor using is
prohibited by Radio Law.
Note
f Projectors that can be connected to [S-DIRECT] or [M-DIRECT] are up to 10.
f When [WIRELESS LAN] is set to [S-DIRECT] or [M-DIRECT] and the input signal is other than [Panasonic APPLICATION],
the normal wireless connection is disabled.
[WIRELESS DETAILED SETUP]
You can configure more precise network settings, if you select [M-DIRECT] or [USER1]~[USER3] (user) for [WIRELESS
LAN] in the network menu. For network settings, contact your network administrator.
Detailed setup of [M-DIRECT]
Use this setting when the projector is used as a simple access point. Even if there is no access point, you can still connect
the projector to computer via the infrastructure.
In addition, the connection with iPad / iPhone / iPod touch / Android is much easier.
1) Press the <ENTER> button when [M-DIRECT] is selected.
f The [WIRELESS DETAILED SETUP] screen is displayed.
2) Press as to select an item, and press qw to change the setting according to the instructions.
[IP ADDRESS]
[SUBNET MASK]
[SSID]
[CHANNEL]
[KEY]
3) Press as to select [OK], and press the <ENTER> button.
r Default setting of [M-DIRECT]
f The following settings are set before the projector leaves the factory.
86 - ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]
When do not use the wireless LAN function.
When use the wireless LAN function via the software "Wireless Manager ME6.0". For
details, refer to the operating instructions of "Wireless Manager ME6.0".
Use this setting when the projector is used as a simple access point.
Even if there is no access point, the connection is enabled when the Wireless
Manager is installed in iPad/iPhone/iPod touch and Android, Windows/Mac.
Sets the detailed setup of network.
Enter the IP address.
Enter the subnet mask.
Select M-DERECT in Wireless LAN, then the SSID can be set.
Select M-DERECT in Wireless LAN, then the Channel can be set.
1~11
Select M-DERECT in Wireless LAN, then the KEY can be set.
Setting a key for the access point. Input either 8 to 63 alphanumerics or a 64 digit
string in the hexadecimal format.
OFF
192.168.10.100
255.255.255.0
192.168.10.1
NONE