Pickups for the jack
16 cm
A
34 cm
B
Position the jack and raise the vehicle
Use the jack from the tool kit.
›
Position the jack at the jacking point closest to the
wheel to be replaced.
›
Insert the crank into the mount on the car jack.
›
Support the base plate of the jack with its full area
resting on level ground and ensure that the jack is
located in a vertical position at the jacking point.
›
Use the crank to raise the jack until its claw enclo-
ses the bar.
Some vehicles may have
anti-theft wheel bolts
that protect the wheels
from theft.
›
Insert the upper sec-
tion on the anti-theft
wheel bolt until it
stops.
›
Place the key on the
wheel bolt or on the
attachment piece.
›
Turn the screw a maxi-
mum of half a turn so
that the wheel does
not come loose and fall
off.
Wheels ›
›
Continue to lift the vehicle until the wheel is just
off the floor.
Changing a wheel
›
Unscrew the screws and place them on a clean
surface.
›
Remove the wheel carefully.
›
Attach the wheel.
›
Slightly screw in the screws.
›
Lower the vehicle.
NOTICE
Applies to factory installed or from ŠKODA Origi-
▶
nal wheel covers supplied: Install the anti-theft
wheel bolt according to the position marked on the
back of the wheel cover.
Tighten screws
›
Tighten the opposite wheel bolts including the an-
ti-theft wheel bolt one after the other.
›
Reinstall the cover caps of the wheel bolts or the
full wheel covers.
Keep the label with the code number of the anti-
theft wheel bolts. Based on this, a replacement at-
tachment piece can be purchased from the ŠKODA
Original parts.
Breakdown kit
Content overview
The kit is located in a box under the floor covering in
the luggage compartment.
Stickers with the speed indication
A
Valve insert driver
B
Filling hose with sealing plug
C
Air compressor (the layout of the controls may
D
be different depending on the type of air com-
pressor)
Tyre inflation hose
E
Button for pressure reduction
F
Pressure display
G
12 volt cable connector
H
ON and OFF switch
I
Breakdown kit
193