Seek Tuning; Direct Tuning - Jensen VM9725BT Operating Instructions Manual

Menu Page 2
13. Back icon: Touch to go to Menu Page 1.
14. CHG PW icon: Touch to go to the change password screen.
15. Mem icon: Touch to display screen used to enter current channel into preset
memory.
16. Scan icon: Touch to scan to the next available channel. The tuner will pause
for approximately five seconds at that channel. Touch scan again to listen to
that channel. If scan is not touched, the tuner will automatically seek the next
channel.
17. Band icon: Only ten preset channels will display at a time. Touch this icon to
display the next band of preset channels. Three bands are available: Band 1,
Band 2, and Band 3.
Switching to SiriusXM® Radio
• Touch the top left corner of the screen (the radio box) to view the Source Menu.
Touch the SiriusXM icon.
• Press the SRC button on the front panel to switch to the SXM source.
Selecting the SiriusXM® Band
Touch the Band icon on the screen to change between the following bands:
Band1, Band2, and Band3.

Seek Tuning

• To seek the next higher channel, touch the
• To seek the next lower channel, touch the

Direct Tuning

To enter a SiriusXM® radio channel directly:
1. On the SiriusXM® menu page 1, touch the
Entry Menu.
2. Enter the desired SiriusXM® radio channel using the on-screen number pad
then press the ok icon. If you wish to delete an entry number touch the red X
icon.
3. To exit the screen without changing the channel, touch the
72
VM9725BT
icon.
icon.
Direct icon to display the Direct
icon.