Resetting The Nvram Permanently; Workstation Power Cycling - Sun Microsystems Ultra 25 Service Manual

TABLE 10-5
Parameter
output-device
ttya-mode
ttyb-mode
10.5.2.2

Resetting the NVRAM Permanently

When the ok prompt is displayed, typing
NVRAM values and permanently restores the default values for all NVRAM
configuration parameters. See
default values.
10.5.2.3

Workstation Power Cycling

Use one of the following two methods to perform a workstation power cycle by
shutting down and immediately restarting the workstation:
System reboot. A system reboot shuts down any running applications and the
operating system, then restarts the operating system. A system reboot does not
take to the workstation to a standby power state.
Shutdown and power on. Powering off the workstation shuts down any running
applications and the operating system, and takes the workstation to a standby
(power-off) state. To restart the workstation, you must manually press the Power
button, which initiates the boot process.
10-12 Sun Ultra 45 and Ultra 25 Workstations Service and Diagnostics Manual • May 2006
Stop-N Equivalent Configuration Parameters (Continued)
Stop-N Equivalent Value
screen
9600,8,n,1,-
9600,8,n,1,-
TABLE 10-3
Description
Console output device.
TTYA port default settings.
See "Setting Up for POST"
on page 11-16.
TTYB port default settings.
See "Setting Up for POST"
on page 11-16.
discards any customized
set-defaults
for NVRAM configuration parameter