Servicing And Maintenance Logs - Buderus Logano plus GB312 Installation And Service Instructions Manual

9.11

Servicing and maintenance logs

The inspection and maintenance logs can also be used as templates.
▶ Sign and date the completed inspection work.
Service work
1. Check general condition of heating system (visual inspection and
function check)
2. Checking the gas and water-bearing system components for:
internal leaks
Visible signs of corrosion
signs of ageing
3. Check concentration of additives in heating water
( see additive manufacturer's documentation and "Water quality
4. Checking the heating system operating pressure
5. Check air intake and outlet openings and flue connector
6. Record readings taken:
Pressure differential
Aggregate flue gas temperature t
CO
2 level or oxygen content
Determine extent of contamination:
Clean the burner and heat exchanger as necessary
CO content, free of air
7. Carry out function checks:
Check ionization current
8. Checking for leaks during operation
9. Check that the controller settings are as required ( technical
documentation for controller)
10. Final check of servicing work
Confirmation of properly completed servicing
Company stamp/Date/Signature
Table 20 Servicing and maintenance logs
Logano plus GB312 – 6 720 806 273 (2013/01)
A
(O )
2
If any condition requiring maintenance work is identified
in the course of inspection, that work must be carried out
as required.
Page Maximum load Minimum load
-
-
-
41
32
36
____in W.C. ____in W.C.
________ °F ________ °F
________ % ________ %
______ ppm ______ ppm
37
________ μA ________ μA
38
–
–
Heating system inspection
Maximum load Minimum load
____in W.C. ____in W.C.
________ °F ________ °F
________ % ________ %
_____ ppm ______ ppm
________ μA ________ μA
9
49