Usb Interface - Kyocera FS-C5350DN Advanced Operation Manual

Password
_
>I/F Block
>>USB Host
? Unblock
Using the Operation Panel
Password (Administrator Password input)
To set up the Security functions, you must enter an administrator ID and
administrator password. For information on how to set the administrator
password, refer to Admin (Administrator settings) on page 2-81.
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows Password
(Administrator password input) and a blinking cursor (_).
2
Press or
blinking cursor. Enter the specified password. Use
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Press [OK]. The Security screen appears.
I/F Block (Interface (external device) block setting)
You can use this to block the interface and thereby disable data
communications. The options available in Interface Block are as follows:
• USB Host (USB memory slot setting)
• USB Device (USB interface setting)
• Optional interface (Network interface card setting)
1
After entering the administrator ID and password, press
>
repeatedly until >I/F Block
USB Host (USB memory slot setting)
This locks and protects the USB memory slot (USB host). The default
setting is Unblock.
1
Press while >I/F Block
appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select Block or Unblock using
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
to increase or decrease, respectively, the value at the
> appears.
> is displayed. >>USB Host
or
and to move
or
.
2-67