Playing The Jupiter-50 From An External Midi Device; Setting The Receive Channel; Setting The Program Change Receive Switch - Roland Jupiter-50 Owner's Manual

Playing the JUPITER-50 from an
External MIDI Device
Connection example
MIDI keyboard
JUPITER-50

Setting the Receive Channel

You'll need to match your external MIDI device's transmit channel
with the JUPITER-50's receive channel.
1.
In the SYSTEM SETUP screen (p . 75), press the [F4] (MIDI)
button .
2.
Use the Part Channel settings (UPPER, SOLO, PERC/
LOWER) to specify the MIDI channel for each part .
3.
To save the settings, press the [WRITE] button .
The screen will ask "Are you sure?"
4.
Press the [F5] (OK) button .
A message will indicate "Completed!" and the settings will be saved.
Setting the Program Change Receive
Switch
1.
MIDI OUT connector
2.
MIDI IN connector
3.
4.
Connecting an External MIDI Device
Here's how to on/off the receive switch for program change and
bank select messages. With the factory settings, both are turned
"ON. "
In the SYSTEM SETUP screen (p . 75), press the [F4] (MIDI)
button .
Turn ON the "Receive Program Change" and "Receive Bank
Select" settings under "MIDI Receive . "
To save the settings, press the [WRITE] button .
The screen will ask "Are you sure?"
Press the [F5] (OK) button .
A message will indicate "Completed!" and the settings will be saved.
MEMO
• For details on these settings, refer to "MIDI ([F4] button)" (p. 77).
• For details on how to set the transmit channel of your external
MIDI device, refer to its owner's manual.
83