Figure 2-11. Removing The Display - HP Omnibook XE3 Service Manual

Screws,
M2.5x4 mm (2)
Reassembly Notes
•
While installing the hinge screws, support the display so that it remains approximately flat.
•
Before installing the switchboard PCA, make sure the large display cable lies within the notch in
the hinge saddle.
•
When installing a new display assembly, follow the procedure given in "Installing a New Display
Assembly" on the following page.
HP Omnibook XE3 (Technology Code GF)
Screws (flanged)
M2.5x8 mm (4)

Figure 2-11. Removing the Display

Removal and Replacement 2-17