HP Omnibook XE3 Service Manual page 93

Code Suggestions
Fan Tests
9001h If the fan is already running, you may not hear
a change. Check the heatsink connection.
Replace the heatsink. Replace the
motherboard.
9002h Reset the notebook. Replace the motherboard.
Microphone Tests
9003h Replace the top case. Replace the
motherboard.
9004h Replace the motherboard.
USB Port Test
9006h Make sure a USB device is connected to the
USB port being tested. Select the correct
speed for the device. Try another USB device.
Replace the motherboard (or dock component,
if applicable).
IR Tests (FIR enabled, undocked)
9002h Reset the notebook. Replace the motherboard.
9007h – Reset the notebook. Run BIOS Setup and
9008h restore default settings. Replace the
motherboard.
9009h Do not run this test in Windows. For the one-
unit test, replace the motherboard. For the two-
unit test, make sure the IR ports on the
reflector and test computers are lined up and
unobstructed. Replace the motherboard.
900Ah Repeat the test. For the two-unit test, make
sure the IR ports on the reflector and test
computers are lined up and unobstructed.
Replace the motherboard.
900Ch Repeat the test. Make sure the IR ports on the
reflector and test computers are lined up and
unobstructed. Restart the reflector unit.
Replace the motherboard.
Sound Tests
9018h – If this error occurs for external headphone,
901Ah replace the motherboard. Otherwise, check
speaker connections. Replace the top case.
3-28 Troubleshooting and Diagnostics
Code Suggestions
Dock Tests
9071h, Update the notebook BIOS. Replace the dock's
9073h electronics PCA.
9075h, Replace the dock's electronics PCA.
9077h –
907Ah
907Bh Replace LED/button assembly in dock.
907Eh Update the notebook BIOS. Replace the dock's
electronics PCA.
9082h Rerun test with known good computer. Replace
electronics PCA in dock.
9085h Restart the computer and repeat the test.
9088h Replace electronics PCA in dock.
Hard Disk Tests
Failure may occur soon. Back up data and
9602h
replace the hard disk.
Repeat the hard disk test. If other errors occur,
9603h
follow the instructions for those errors.
9604h Back up data if possible, then reinstall
applications. Use the Recovery CDs to
reformat the hard disk and reinstall factory
software.
9605h Run the full HDD test, For a notebook that
does not give an F10 prompt at boot (no
Hibernate partition) or that has a non-Windows
operating system, this error may not indicate a
failure. Otherwise, use the Recovery CDs to
reformat the hard disk and reinstall factory
software.
9606h Run the full HDD test. Use the Recovery CDs
to reformat the hard disk and reinstall factory
software.
9607h Back up data if possible, then use the
Recovery CDs to reformat the hard disk and
reinstall factory software. Replace the hard
disk.
HP Omnibook XE3 (Technology Code GF)