HP Omnibook XE3 Service Manual page 64

Component
Doors, PCMCIA
Drive, CD/DVD
Drive, floppy disk
Heatsink (with fan)
Keyboard
PCA, CD player
PCA, headphone
PCA, motherboard
PCA, switchboard
HP Omnibook XE3 (Technology Code GF)
Removal Procedure
Mini-PCI PCA (page 2-6).
Keyboard cover
(page 2-8).
Keyboard (page 2-10).
Hard disk drive
(page 2-12).
Display assembly
(page 2-16).
Top case (page 2-19).
Hinge saddle set
(page 2-22).
Heatsink assembly
(page 2-24).
CPU module (page 2-26).
Floppy disk drive
(page 2-29).
CD/DVD drive
(page 2-31).
Motherboard (page 2-32).
See page 2-31.
See page 2-29.
See page 2-24.
See page 2-10.
See page 2-21.
Keyboard cover
(page 2-8).
Keyboard (page 2-10).
Display assembly
(page 2-16).
Top case (page 2-19).
Hinge saddle set
(page 2-22).
See page 2-32.
Keyboard cover
(page 2-8).
Keyboard (page 2-10).
Additional Steps
See the figure on page 2-37.
Remove the retaining screw from the PCA, disconnect
the cable to the motherboard, and lift the PCA out of
the notebook. You can lift the floppy drive slightly for
access.
Remove both screws (M2.5x4 mm) from the PCA, and
carefully lift the PCA off of the connector beneath it. Be
careful not to pull on the cable attached to the PCA.
Disconnect the cable from the PCA and remove the
PCA from the notebook.
Removal and Replacement 2-39