How to Upgrade Firmware
Required environment:
A. Crossover Cat. 5 cable
B. Windows 2000 or later
C. Network card on local PC.
D. EAN600.
Please follow those steps, which at below:
Step 1 Set network configuration on you local PC.
Please go to "Internet Protocol (TCP/IP) Properties".
Start > Setting > Control Panel > network and Dial-up Connections > Local Area
Connection > Properties > Internet Protocol (TCP/IP) > Properties
Please fill in those numbers, which at below for setting IP configuration
IP:192.168.1.200
Net Mask:255.255.255.0
Default Gateway: 192.168.1.1
Those setting are following Ethernet standard. You can fill any value numbers
that you like, but have to follow Ethernet standard. After you into "Internet
Protocol (TCP/IP) Properties" and you will see "Internet Protocol (TCP/IP)
Properties" configuration at below.
27
EAN600