Section 4-Front Riggings; Installing/Removing Swingaway Front Riggings; Installing; Removing - Invacare Compass SPT PH904A Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
SECTION 4—FRONT RIGGINGS
After making adjustments, always make sure that parts are properly tightened
BEFORE using the wheelchair.

Installing/Removing Swingaway Front Riggings

If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE: For this procedure, refer to FIGURE 4.1.

Installing

1. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and
position mounting holes in the front rigging hinge plates with hinge pins on the
wheelchair frame.
2. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.
3. Push the front rigging towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for opposite side of
wheelchair.
5. If necessary, adjust the footrest height.
Refer to Installing/Removing
Swingaway Front Riggings on page 30

Removing

1. Pull the front rigging release lever and
rotate the footrest outward.
2. Lift up on front rigging and remove
from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of
wheelchair.
Compass™SPT™
WARNING
CAUTION
Hinge
Pins
Front
Rigging
Release
Lever
FIGURE 4.1 Installing/Removing Swingaway
30
Telescoping Front
Rigging Support
Front
Rigging
Hinge
Plate
Front Riggings
Part No 1122134