Composite/Articulating Footplate Heel Loop Replacement; Disassembly; Reassembly; Installing/Removing Elevating Legrests - Invacare Compass SPT PH904A Owner's Operator And Maintenance Manual

Composite/Articulating Footplate Heel Loop
Replacement
NOTE: For this procedure, refer to FIGURE 4.8.

Disassembly

Composite.
1. Remove the hex screw and coved
spacer that secure the lower footrest
assembly to the swing away footrest
assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and
locknut that secure the heel loop to the
footrest.
4. Slide heel loop off of the footrest.
Articulating.
1. Remove the mounting screws, washers
and spacers that secure the heel loop to
the articulating footplate.

Reassembly

1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the
footrest assembly, tighten mounting screw
until the spacer is secure.

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.9 on page 36.

Installing

1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into
the mounting tube.
2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.
3. Repeat STEPS 1-3 for the other elevating legrest assembly.
Part No 1122134
SECTION 4—FRONT RIGGINGS
COMPOSITE FOOTPLATE
Swingaway Footrest Assembly
Philips
Screw
Lower Footrest
Spacer
Heel
Loop
Locknuts
Spacer
ARTICULATING
FOOTPLATE
FIGURE 4.8 Composite/Articulating
Footplate Heel Loop Replacement
35
Hex Screw and
Coved Spacer
Philips
Assembly
Screw
Washer
Heel
Loop
Compass™SPT™