Composite/Articulating Footplate Heel Loop Replacement; Disassembly; Reassembly; Replacing Sector Block - Invacare Compass SPT PH904A Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
Composite/Articulating Footplate Heel Loop
Replacement
NOTE: For this procedure, refer to FIGURE 4.12.

Disassembly

Composite
1. Remove the hex screw and coved spacer that secure the lower footrest assembly to the
swing away footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and
locknut that secure the heel loop to the
footrest.
4. Slide heel loop off of the footrest.
Articulating
1. Remove the mounting screws, washers
and spacers that secure the heel loop to
the articulating footplate.

Reassembly

1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the
footrest assembly, tighten mounting screw
until the spacer is secure.

Replacing Sector Block

NOTE: For this procedure, refer to
FIGURE 4.13.
1. Remove the hex screw and washer that
secure the existing sector block to the
front rigging support tube.
2. Position the new sector block on the
front rigging support tube. Make sure
the locking pin is facing up.
3. Secure the new sector block to the front
rigging support tube with the existing
hex screw and washer.
Compass™SPT™
Composite Footplate
Swingaway Footrest Assembly
Hex Screw and
Mounting
Coved Spacer
Screw
Lower Footrest
Assembly
Spacer
Heel
Loop
Locknut
Articulating
Footplate
FIGURE 4.12 Composite/Articulating
Footplate Heel Loop Replacement
Wheelchair
Frame
Locking Pin
FIGURE 4.13 Replacing Sector Block
38
Mounting
Screws
Washer
Heel
Loop
Spacer
Hex Screw
Washer
Sector Block
Part No 1122134