70° Mfx, 90°, 70° Lift And 90° Lift Footrests; Model Phw93 And Ph904A Front Riggings - Invacare Compass SPT PH904A Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
4. Securely tighten the hex screw and
coved spacer.
5. Install the footrest assembly onto the
wheelchair. Refer to
Installing/Removing Swingaway Front
Riggings on page 30.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair, if necessary.
70° MFX, 90°, 70° LIFT and 90° LIFT Footrests
NOTE: For this procedure, refer to FIGURE 4.4.
1. Remove any accessories that are attached to the footrests.
2. Remove the socket bolt, coved washer and locknut that secure the footplate to the
footrest support.
3. Reposition the footplate to the desired
height.
4. Reinstall the socket bolt through the
mounting holes of the footplate and
footrest support.
WARNING
DO NOT overtighten socket bolt and
locknut. Footrest MUST be able to
rotate upward from the horizontal to
the vertical position.
5. Secure the footplate to the footrest
support with the coved washer and
locknut.

Model PHW93 and PH904A Front Riggings

NOTE: For this procedure, refer to FIGURE 4.5 on page 33.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Swingaway
Front Riggings on page 30.
NOTE: Lay footrest on a flat surface to simplify procedure.
Compass™SPT™
Hex Screw
Coved
Spacer
Footrest
FIGURE 4.3 Adjusting Footrest Height -
60°, 70° and 70° Taper
Locknut
Footplate
FIGURE 4.4 Adjusting Footrest Height -
70° MFX, 90°, 70° LIFT and 90° LIFT
Footrests
32
Footrest Upper
Support
Mounting
Tube
Footrest Support
Height
Adjustment
Holes
Socket Bolt
Part No 1122134