9.3
Connecting the pedal
9.4
Securing the stand
10
1
2
–
Place the pedal 1 under the stand.
–
Remove the handwheel and the belt protection of the automat.
–
Guide the cable of pedal 1 through the cable duct of the automat
to the top. Fix the cable to the underside of the table top using
the provided cable clip.
–
Connect the cable of pedal 1 with bush 2 (X406).
–
Put the belt protection and the handwheel back again.
1
2
–
Screw the two support plates down with nut 1 until the automat
stands firmly and safely.
–
Screw the counternut 2 upwards and tighten it.