DURKOPP ADLER 580 Operating Instructions Manual page 46

1 2
1
4
44
Removing the finished workpiece with the subclass 580-151000
–
In order to remove the finished workpiece pull the looper thread
and the gimp under the thread clamp 2. Pull both threads from the
right to the left along the blade 1.
The threads are cut.
Replacing the knife
–
Loosen screw 1 and remove the fabric holder 4.
–
Take out the old blade 2.
–
Push the new blade 3 as far as it will go into the groove and snap
it off in the direction indicated by the arrow.
–
Tighten the screw 1.
–
Fix the holder by using the screw 4.
Hint!
The blade must not protrude
the holder.
2
1
3