To Modify A One-Touch Number - AT&T 1070 User Manual

VIEW
5550100
MODIFY
One-touch setup and operation

To modify a one-touch number

Use the following steps to modify a one-touch
number.
SPD#01
1. When a one-touch telephone number is
displayed, press [ ] or [ ] to highlight MODIFY.
2. Press [ENTER].
3. Press the dial pad keys to enter up to 24 digits.
•
•
•
•
•
•
You can include a pause while modifying
a dialing sequence that requires one during
actual dialing. Press [ ] or [ ] until you see
PAUSE, then press [ENTER] when storing
a pause. The screen displays P. Each pause
counts as one digit. Continue storing the
number as usual.
Storing a signal for switching to temporary
tone dialing is required for some special
service if you have dial pulse (rotary) service.
Press [ ] or [ ] until you see TONE, then
press [ENTER]. A T appears on the screen.
All numbers entered after this send touch
tone signals during dialing.
You can store the flash signal required by
some special services as part of a dialing
sequence. Press [ ] or [ ] until you see
FLASH, then press [ENTER]. An F appears on
the screen. Continue storing the number as
usual.
To erase the last digit, scroll to DELETE
CHAR and then press [ENTER].
-OR-
Press [REMOVE].
To copy the most recently dialed number
from redial, press [(AUTO) REDIAL]. You
can copy only the last number dialed from
this extension to a one-touch location. You
cannot copy the other numbers in the redial
stack.
To cancel programming, scroll to CANCEL
and then press [ENTER].
40
Continued on next page