Control Unit (Option) - Panasonic AJ-D910WB Operating Instructions Manual

CONTENTS
Connecting the AJ-EC3E Extension Control Unit (Option)
Connecting the AJ-EC3E extension control unit (option) allows a portion of the camera section functions to be operated by
remote control.
When the AJ-EC3E is connected and the POWER switches of the unit and AJ-EC3E are set to ON, the unit automatically enters
remote control mode.
The handling instructions included with the AJ-EC3E describe operations for when the AJ-EC3E is connected to an AQ series
digital camera.
When the AJ-EC3E is connected to the AJ-D910WB, some functions differ, and some features cannot be used.
ECU Connector
|Notes{
ÁThe POWER switches of the unit and AJ-EC3E must be set to OFF before the 6-pin cable is
connected or disconnected.
ÁWhen OFF has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE page
of MAIN menu screen 2 of 4
All adjustments and settings made using the switches and controls on the menu setting section
of the AJ-EC3E are erased when the unit's POWER switch is set to OFF. Neither is it possible
to save any of the adjustments and settings—except for the menu settings—performed using
the AJ-EC3E's switches and controls on the setup card. However, when the AJ-EC3E is con-
nected again, these settings return to the AJ-EC3E settings.
(Menu contents set with the menu setting section are saved.)
For use in this mode, set the POWER switch on the AJ-EC3E to the OFF position before the
unit's POWER switch is set to OFF. If the unit's POWER switch is set to OFF before the
POWER switch on the AJ-EC3E is set to the OFF position, the adjustments and settings per-
formed when the AJ-EC3E was operated will be saved instead.
ÁWhen ON has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE page
of MAIN menu screen 2 of 4
The adjustments and settings performed using the switches and controls on the AJ-EC3E's
menu setting area will not be lost even when the unit's POWER switch is set to the OFF posi-
tion.
|Note{
The functions of the AJ-EC3E are limited as follows.
ÁThe STORE switch does not function.
(If the menu settings are changed while the AJ-EC3E is connected to the AJ-D910WB, the new
menu settings are saved automatically as soon as the changes are made.)
Note that the AJ-EC3E gain switch displays p3, 0 and 9 correspond to L, M and H, and the
OUTPUT switch settings CAMERA, TEST and BAR to CAM/AUTO KNEE ON, CAM/AUTO
KNEE OFF and BAR for each main unit.
ÁThe Synchro scan and Super V modes cannot be used while the AJ-EC3E is connected to the
unit.
ÁThe lens iris (IRIS) control of the AJ-EC3E is valid only when the lens iris AUTO/MANUAL selec-
tor is set to AUTO.
– 47 (E) –
6 pin Cable (VJA1056)
This parts is available as service parts.
For further details, consult with your dealer.
ECU AJ-
ECU
6 5
∫
1
R B
AJ-EC3E