Panasonic AJ-D910WB Operating Instructions Manual page 106

CONTENTS
Recording With an External VTR Instead of the Internal VTR
2
Mount the 26-pin/12-pin output adaptor.
Controlling the external VTR with the unit's switches
Setting the 26P CONTROL function as indicated below on the "VTR FUNCTION" SUB menu page
of the MAIN menu screen 2 of 4 prevents the internal VTR from being operated and enables only
the external VTR to be controlled by the VTR START button on the unit or by the VTR button on
the lens.
Á26P CONTROL: ON
ÁSee "Selecting Functions" (page 70) for a description of the VTR FUNCTION page operations.
Switching from the internal VTR to the external VTR
If the internal VTR should develop a problem (such as an entangled tape or condensation) during
operation and it can no longer be operated, the VTR START button on the unit and the VTR button
on the lens will cease to function.
In these cases, it will be possible to operate the external VTR in place of the internal VTR using
the VTR START button on the unit and the VTR button on the lens if the 26P CONTROL function
on the VTR FUNCTION page is set as indicated above.
Starting recording
Operate the external VTR to set it to recording paused status and press the VTR START button of
the unit or the VTR button of the lens. The external VTR starts recording. Pressing the button
again sets the VTR to the recording paused status.
Output level of the 26-pin/12-pin output adaptor
The output level factory settings are p60 dBu/balanced for audio. When the built-in SW4701
switch is set, the audio output level can be changed to p20 dBu/unbalanced. When the compo-
nent level is used, set both 1 and 2 of SW1 on the CAM ENC board always to ON. (See previous
page)
– 106 (E) –