Power Supply - Panasonic AJ-D910WB Operating Instructions Manual

CONTENTS

Power Supply

Using an Anton Bauer Battery Pack
Power can be supplied to the unit using a battery pack or AC power supply.
Using a battery pack
A battery pack which is made by any of the four following manufacturers can be used:
A Panasonic, B Anton Bauer, C Sony or D IDX.
Before using a battery pack, be sure to charge it completely using a battery charger.
ÁSee the Handling Instructions for the battery pack and battery charger for a detailed explanation
of charging methods.
1
Mount the battery pack.
Insert the battery pack in the direction of the arrow and then slide it into place.
2
When detaching the battery, hold down the detachment lever of the battery holder and slide
the battery pack in the direction of the arrow.
Lever
|Note{
The AJ-D910WB supports the intelligent battery system and the ultra-light system.
Automatic detection can be performed for intelligent batteries with a remaining battery level of
10% or more. At this time, the remaining battery level is displayed numerically (percentage
display) inside the viewfinder. If the power is turned on with a remaining battery level of 10%
or less, the voltage is displayed. When external power is supplied after intelligent battery
sensing, the remaining battery charge display switches to the externally supplied voltage
display.
– 24 (E) –
Power Supply Output Connector
Control Switch
Pack