Cameras - Panasonic AJ-D910WB Operating Instructions Manual

CONTENTS
Maintenance
Condensation
Cleaning the Video Heads
Cleaning the Viewfinder
Characteristic Phenomenon of CCD Cameras
If the unit is moved from a cold location to a warm location or used in areas with high humidity, the
moisture in the air may adhere as water droplets on the head drum. This is called condensation,
and if the tape is run under these conditions, it will easily stick to the drum. Therefore, the following
points should be observed.
ÁIf the unit is moved under conditions where condensation may occur, eject the tape.
ÁBefore inserting the tape, set the POWER switch to ON and check that the HUMID display in the
display window is not lit. If the HUMID display is lit, do not insert the tape until the display goes
off.
|Note{
To ensure safe operation, MID continues to flash for 80 minutes after the condensation detection
has been released. During this period, the function buttons will not respond even when they are
operated.
Use the AJ-CL12MP cleaning cassette when head cleaning is required. Improper use of the
cleaning cassette may damage the video heads. Therefore, read the Handling Instructions for the
cleaning tape carefully before use.
ÁDo not use thinner or other solvents to remove dirt from the viewfinder.
ÁWipe the lens with lens cleaner available on the market.
ÁAbsolutely do not wipe the mirror. If dirt, etc. has adhered to the mirror, remove it using a air
blower available on the market.
Smear
Smear occurs when shooting high-intensity subjects, and occurs more easily as the electronic
shutter speed increases.
– 153 (E) –
The HUMID display
is not lit.