Panasonic AJ-D910WB Operating Instructions Manual page 103

CONTENTS
Recording Simultaneously with the Internal VTR and an External
VTR
Connections
Checking the Function Settings
Starting Recording
If One VTR Comes to the End of its Tape During Recording
Mount the AJ-YA900P 26-pin/12-pin output adaptor (option) to the unit, connect the external VTR
with the 26-pin cable, and set the audio input level selector switch of the external VTR to
"p60 dB".
SW201 on the CAM ENC Printed Circuit Board of the unit must be set to ON side.
(See page 105.)
Audio input level selector switch: p60 dB
Portable VTR
(Set the audio input level
selector switch to p60 dB.)
Check that the function to control the 26-pin interface has been set to "BOTH" or "ON" on the "VTR
FUNCTION" SUB menu page of the MAIN menu screen 2 of 4. See "Selecting Functions" for a
description of the various function settings.
1
Operate the external VTR and set it to recording paused status.
2
Press the VTR START button of the unit or the VTR button of the lens. The internal and
external VTRs start recording simultaneously. Pressing the button again sets both VTRs to
the recording paused status.
Even if one VTR comes to the end of its tape and stops, the other VTR continues recording oper-
ation.
Returning the VTRs to simultaneous recording status
ÁIf the internal VTR came to the end of its tape, replace the cassette and press the VTR START
button of the unit or the VTR button of the lens. The external VTR continues recording operation
during this time.
ÁIf the external VTR came to the end of its tape, replace the cassette and operate the external
VTR to restart recording. The internal VTR continues recording operation during this time.
|Note{
Care should be taken as the internal VTR will assume recording paused status if the VTR START
button of the unit or the VTR button of the lens is pressed after replacing the external VTR's
cassette.
– 103 (E) –
To the 26-pin connector of the
AJ-YA900P (See page105 for mounting the
26-pin/12-pin output adaptor)