Panasonic AJ-D910WB Operating Instructions Manual page 16

CONTENTS
Controls and Their Functions
Shooting (Recording)/Playback Function Section (2)
¨
≠
(The viewfinder shown in the
illustration is the AJ-VF10E.)
¬ CC/ND FILTER (filter selector) knob
This selects the filter to match the light source which is illuminating the subject.
If the setting of this knob is changed when the menu display mode has been set to "3", the new
setting will appear on the setting change message display area of the viewfinder screen.
È The knob and filter settings are listed below.
Filter
Description
knob setting
A Cross
B 3200K
C 4300K
D 6300K
1 Clear
2 1/4ND
3 1/16ND
4 1/64ND
­ Synchro scan adjustment switches
These switches are used to adjust the synchro scan speed. Pressing the "p" switch reduces
the shutter speed; pressing the "o" switch increases the shutter speed. Set these switches to a
position where the side bar noise in the viewfinder is eliminated during personal computer
monitor shooting, etc.
|Note{
When these switches are used for UB/TC/CTL settings while the SET position has been select-
ed as the TCG switch position, they will not serve their function as synchro scan adjustment
switches. The TCG switch must be set to F-RUN or R-RUN for these switches to serve their
function.
® WHITE BAL (white balance memory selector) switch
PRST: Set to this position when there is no time to adjust the white balance. The white bal-
ance value for 3200K is stored in the memory.
A or B: When the AUTO W/B BAL switch ± is pressed to the AWB side, the white balance
is automatically adjusted in accordance with the setting position of the filter knob ¬,
and the adjustment value is stored in memory A or memory B.
When the FILTER knob and the WHITE BAL switch are set to the same positions as the ones
set when the adjustment was made, the adjustment value stored in the memory is called, and
the unit is automatically adjusted to the white balance which corresponds to this value.
If the setting of this switch is changed when the menu display mode has been set to "3", the
new setting will appear at the WHITE BAL switch display position on the viewfinder screen.
(Example: "A")
– 16 (E) –
Æ
Example of filter setting to match shooting conditions
For setting the light source into the shape of a cross.
Dawn, dusk, inside a studio
Outdoors under a clear sky, outdoors in the rain
At the beach, in mountains covered with snow
Indoors, studios, dark places
Outdoors under a cloudy sky
Outdoors under a clear sky
Outdoors, at the beach or in mountains covered with snow in summer