Adjusting The White Balance - Panasonic AJ-D910WB Operating Instructions Manual

CONTENTS
Adjusting the White Balance/Black Balance

Adjusting the White Balance

Adjusting the white balance and black balance in the order of AWB (white balance
adjustment)>ABB (black balance adjustment)>AWB will provide a better picture.
The black balance does not normally need to be readjusted even when the power is turned off and
then turned back on.
However, the white balance must be readjusted when the lighting conditions change.
If black balance and white balance adjustments are started when the display mode is set to "2" or
"3", messages informing of the adjustment course and results will appear on the viewfinder
screen. Set the display mode to "1" to not display these messages.
ÁSee "Display Mode and Setting Change Message" (page 62) for a description of setting the
display mode.
|Notes{
ÁThe white balance and black balance cannot be adjusted while the setting menu appears on the
viewfinder screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.
ÁThe auto black balance (ABB) must be readjusted without fail when the MASTER GAIN value
has been changed on the "LOW SETTING", "MID SETTING" or "HIGH SETTING" SUB menu
pages of MAIN menu screen 1 of 4, when the super gain setting has been changed using the
SUPER GAIN button, and when the GAMMA setting (ON/OFF) on the "CAMERA SETTING"
SUB menu page of MAIN menu screen 1 or 4 has been switched.
1
Set the switches as shown in the figure.
FILTER knob
When the positions of the GAIN and WHITE BAL switches are changed, a message informing
the operator of the new settings will appear on the setting change message display area of
the viewfinder screen. (However, this display appears only when the display mode is set to
"3".)
2
Select the FILTER knob setting in accordance with the lighting conditions.
ÁRefer to the description of the ¬ FILTER knob (page 16) in the Shooting and Recording/
Playback Function Section for examples of the FILTER knob settings. If the FILTER knob
setting is changed, a message informing the operator of the new setting will appear on the
setting change message display area of the viewfinder screen. (However, this display ap-
pears only when the display mode is set to "3".)
– 71 (E) –
MENU SET/OFF: OFF
WHITE BAL: A or B
OUTPUT: CAM
GAIN: Normally, set to 0 dB. When it is too dark,
it is set to the appropriate gain.