How To Install The Hob - CDA HVN61 Manual For Installation, Use And Maintenance

Hide thumbs Also See for HVN61:

Table of Contents

How to install the hob:

Overall dimensions of the hob:

HVN61FR: Width: 580 mm

HVN81FR: Width: 770 mm

Worktop cut-out dimensions:

HVN61FR: Width: 560 mm

HVN81FR: Width: 750 mm

1. Make the required hole in the worktop. Before doing this, you must

check the instructions supplied with any cooker hood to ensure that

you will have the required clearance. The cut-out (Fig.6) shows a

60mm gap from the wall to the cut-out edge. The distance from the

hob, when fitted, to the back wall is 50mm.

If a splashback/worktop upstand is to be fitted, take this into account

when cutting the hole. The minimum distance that the hob should

be positioned away from the rear wall or splashback is 50mm.

2. Fix the foam seal underneath the appliance by following the outline

of the worktop upon which the hob will rest. This ensures an airtight

seal with the worktop. Do not use silicone type sealant.

Depth: 510 mm

Depth: 490 mm

Table of Contents

Hvn81