Table of Contents
Advertisement
How to install the hob
Overall dimensions of the hob:
Width: 900 mm Depth: 350 mm
Worktop cut-out dimensions:
Width: 885 mm Depth: 340 mm
1. Make the required hole in the worktop.
Before doing this, you must check the
instructions supplied with any cooker hood to ensure that you will
have the required clearance. The cut-out (Fig.8) shows a 60mm gap
from the worktop edge to the cut-out edge. The distance from the
hob, when fitted, to the back wall is to be 50mm.
If a splashback/worktop upstand is to be fitted, take this into account
when cutting the hole. The minimum distance that the hob should be
positioned away from the rear wall or splashback is 50mm.
Fig.8
22
885
Rear Wall
Cut-out
Front edge of worktop
1
2
1 - Worktop
2 - Hob seal
3 - Ceramic hob
Fig.7
Adjacent vertical surface
(cupboard etc. -
Measurement applicable
to both sides.)
Min.
55
3
Advertisement
Table of Contents
