Table of Contents
Advertisement
On switching on
You observe that
The hob does not work and
the lights on the control
panel do not switch on
The hob is not working and
the display shows a
non-standard graphic
The hob is not working and
the display shows
In use
You observe that
The hob has stopped
operating. The hob beeps
at approximately ten second
intervals and a
displayed on the zone display
A series of small
displayed
After turning on a zone, the
indicator lights on the control
panel continue to flash
The saucepans make noise
during cooking or your hob
makes a clicking sound
during cooking
The fan continues to function
for a few minutes after the hob
is turned off
9
IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking –
even minimal – of the vitroceramic glass, immediately disconnect your appliance to
prevent a risk of electric shock and contact CDA Customer Care.
Possible Causes
The hob is not connected
to the power supply or
the power supply is faulty
The electronics are not
functioning correctly
The childlock is on
Possible Causes
There was an overflow
or an object is in contact
or F7 is
with the control panel
or F7 is
The electronic boards
The cookware used is
not suitable for induction
or is less than 12 cm in
diameter (10 cm on the 16
This is normal with some
types of cookware. This
is caused by the transfer
of energy from the hob to
the cookware
Cooling of the electronic
components.
Working normally
fast frying steaks
heated up
cm zone)
What should you do?
Check the electrical
circuit breaker and fuses
Call CDA Customer Care
Switch off the childlock
before trying to use the
hob.
What should you do?
Clean the hob or
remove the object, and
begin cooking again
See the Installation
section
See the section on
cookware for induction
Nothing. There is no
risk, neither to your hob
nor to your cookware
Nothing.
19
Advertisement
Table of Contents
