Table of Contents
Advertisement
•
This appliance is designed to be installed into cabinet units capable of
withstanding temperatures
80-90°C).
•
The rear wall or splashback the hob is to be fitted in front of must be
made of a flame resistant material
•
If there is no oven to be built in below the hob it is recommended
that, an isolation shelf should be fitted to protect the user from high
temperatures. If the hob is to be installed above a working drawer,
then a partition should be fitted to protect the contents and user from
the heat generated during use. This should be fitted at least 15mm
below the hob. This panel should have a ventilation space at the rear
of greater than 30mm as shown in Fig. 10.
•
Never place perishable foods in the cupboard below the appliance.
How to Install the Hob
How to install the hob:
Overall dimensions of the hob:
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig. 11) shows a
50mm gap from the wall to the cut-out edge.
65°C above ambient or greater (typically
Ventilation slot > 30mm
Fig. 10
Width: 580mm Depth: 500mm
Width: 557mm Depth: 477mm
15mm
19
Advertisement
Table of Contents
