How To Install The Hob - CDA HG7251 Manual

How to Install the Hob

Installation Dimensions (mm)
Worktop cutout width
Worktop cutout depth
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig. 11) shows a
minimum 50mm gap from the wall to the cut-out edge.
2. Position the hob seal, as shown in the diagram below (Fig. 13),
ensuring that the ends meet without overlapping. Do not use silicone
type sealant.
NOTE: The seal is supplied already fitted to the hob on some
models, for your convenience.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig. 14). Remove any
excess seal after tightening the brackets.
20
Overall width
Overall depth
HG7251 &
HG7351
680
500
557
477
HG9351
860
500
832
477