SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Adjusting Footrest Height
NOTE: For this procedure, refer to FIGURE 6.1.
1. Remove impact guards and/or calf strap, if so equipped.
2. Remove the mounting bolt and coved washer.
3. Position the footrest assembly to the desired height.
4. Align the desired footrest tube mounting hole with the footrest support mounting
hole.
5. Using the coved washer and mounting bolt, secure the footrest tube to the footrest
support. Securely tighten.
6. If necessary, repeat STEPS 2‐4 to adjust remaining footrest.
7. Reinstall the impact guards and/or calf strap, if so equipped.
Footrest Support
Footrest Tube
Part No 1143216
WARNING
FIGURE 6.1 Adjusting Footrest Height
33
SECTION 6—FRONT RIGGINGS
Mounting Bolt
Coved Washer
Footrest Assembly
™
AX3
Wheelchair