Section 10-Seat-To-Floor Height; Seat Dump - Invacare AX3 Owner's Operator And Maintenance Manual

SECTION 10—SEAT-TO-FLOOR HEIGHT
SECTION 10—SEAT-TO-FLOOR
HEIGHT
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.

Seat Dump

NOTE: For this procedure, refer to FIGURE 10.1.
NOTE: Refer to Measuring Seat‐to‐Floor Height on page 57 for measuring instructions.
NOTE: Invacare recommends that the rear seat‐to‐floor height be AT LEAST 3/8‐inch shorter than
the front seat‐to‐floor height. Otherwise a forward seat dump can occur.
Subtract the rear seat‐to‐floor height measurement from the front seat‐to‐floor height
measurement to determine the amount of seat dump as shown in the example in
FIGURE 10.1.
Rear
Seat-to-Floor Height
ProSPIN™ X4™
WARNING
Example:
20 inches Front Seat-to-Floor Height
- 19 inches Minus Rear Seat-to-Floor Height
3 degrees Equals Seat Dump
FIGURE 10.1 Seat Dump
56
Front
Seat-to-Floor Height
Part No 1125104