SECTION 12—ANTI-TIPPERS
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an
option on this wheelchair (you may order it with or without the anti-tippers),
Invacare strongly recommends ordering the anti-tippers as an additional safeguard
for the wheelchair user.
Anti-tippers MUST be fully engaged and release buttons fully protruding out of
adjustment holes.
Ensure both anti-tippers are adjusted to the same mounting hole.
Installing/Adjusting Anti-Tippers
Installing Anti-Tippers
NOTE: For this procedure, refer to
FIGURE 12.1.
1. Press release buttons in and insert
anti‐tippers with the anti‐tipper wheels
pointing toward ground/floor into the
rear frame tubing until bottom release
button locks in place.
2. Measure the distance between the
bottom of the anti‐tipper wheels and
the ground/floor.
NOTE: A 1‐1/2 to 2‐inch clearance between
the bottom of the anti‐tipper wheels and the
ground/floor MUST be maintained at all times.
3. If the distance between the bottom of
anti‐tipper wheels and the
ground/floor is not 1½ to 2‐inches,
adjust anti‐tippers.
Part No 1143216
WARNING
Release
Buttons
FIGURE 12.1 Installing Anti-Tippers
61
SECTION 12—ANTI-TIPPERS
Wheelchair
Frame
Anti-Tippers
Rear Frame Tubing
Anti-Tipper
Anti-Tipper Wheel
™
AX3
Wheelchair