Folding Wheel Lock Handles
NOTE: For this procedure, refer to FIGURE 4.4.
1. Pull up and back on the wheel lock handle.
DETAIL
"A"
Installing/Removing the Front Riggings
NOTE: For this procedure, refer to FIGURE 4.5.
NOTE: For maintenance and/or adjustment procedures refer to Front Riggings on page 42.
NOTE: This procedure applies to the swingaway footrests and the elevating legrests.
Installing
1. Turn the front rigging assembly to the side (open front rigging is perpendicular to
wheelchair).
2. Insert footrest mounting pin into mounting tube.
3. Push the front rigging assembly towards the inside of the wheelchair until it locks into
place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat this procedure for the other front rigging assembly.
Removing
1. Push the front rigging release lever inward.
2. Rotate swingaway front rigging assembly outward or inward.
3. Lift the swingaway front rigging assembly off of the mounting tube.
Part No 1143216
Wheel
Lock
Handle
Wheel Lock
FIGURE 4.4 Folding Wheel Lock Handles
27
SECTION 4—WHEELCHAIR OPERATION
DETAIL
"B"
Wheel Lock
Handle
Wheel Lock
™
AX3
Wheelchair