SECTION 6—FRONT RIGGINGS
Replacing Heel Loop
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove the mounting bolt and coved washer that secure the footrest tube to the
footrest support.
2. Remove the lower footrest assembly.
3. Remove the mounting screw, spacer
and locknut that secure the heel loop to
the footplate.
4. Slide heel loop over footrest tube.
NOTE: When securing the heel loop to the
footrest assembly, tighten the mounting screw
and locknut until the spacer is secure.
5. Using the mounting screw, spacer and
locknut, secure the heel loop to the
footplate.
6. Using the mounting bolt and coved
washer, secure the footrest tube to the
footrest support.
Installing Impact Guards/Calf Strap
NOTE: For this procedure, refer to FIGURE 6.3.
1. Remove impact guard/calf strap from packaged container if not already secured to the
front rigging.
2. Secure the impact guards around the front rigging.
3. Secure the optional calf strap around the footrest frame (with the impact guards
attached).
™
AX3
Wheelchair
Front
Rigging
Impact
Guard
FIGURE 6.3 Installing Impact Guards/Calf Strap
Footrest Support
Footrest
Tube
Mounting
Coved
Bolt
Washer
FIGURE 6.2 Adjusting Elevating Legrest
Height and Calfpad Height/Depth
Calf
Strap
34
Mounting Screw
Spacer
Heel
Loop
Footplate
Locknut
Part No 1143216