Ricoh SP C250DN Operating Instructions Manual page 170

7. Troubleshooting
Problem
White lines appear.
DAC607
Horizontal lines appear on the
printed paper.
The print color is different from the
color specified.
Photo images are coarse.
A color is missing or a printed image
is partially blurred.
Color shift occurs.
168
The intermediate transfer belt is dirty.
Follow the procedure below to clean the belt:
1. Open the top cover while the power is on.
2. Remove all print cartridges from the printer.
3. Close the top cover with both hands carefully.
4. When cleaning finishes, open the top cover and attach
all the print cartridges again.
If this procedure does not resolve the problem, contact your
sales or service representative.
• Impact can cause lines to appear on printed paper and
other malfunctions.
Protect the printer from impact at all times, especially
while it is printing.
• If lines appear on prints, turn the printer off, wait a few
moments, and then turn it back on again. Then, perform
the print job again.
If a specific color is missing, turn the power switch off and on.
If this does not resolve the problem, contact your sales or
service representative.
Some applications lower the resolution for making prints.
• The paper being used may be damp. Use paper that has
been stored properly.
See page 54 "Loading Paper".
• Toner is almost empty. If the following message appears
on the control panel, replace the print cartridge:
"Replace Toner: X". ("X" indicates the toner color)
See page 129 "Replacing the Print Cartridge".
• Condensation may have occurred. If rapid change in
temperature or humidity occurs, use this printer only after
it has acclimatized.
Perform the [Color Dens/Reg] under [Maintenance].
For details, see page 88 "Maintenance Menu".
Solution