Rinnai Arriva Operation And Installation Manual page 13

Operation Using the remote Control
Setting the
clock
Lock Auto Off Flame
AM
PM
20
Time
Clock Set
Set
ON OFF
Prior to using the timers ensure the desired temperature has been set, refer previous page.
Setting the
timers
Lock OverrideAuto Off Flame
AM
PM
20
Temperature Time
Clock Set
Timer 1 Set ON OFF
Timer 2 Set ON OFF
Lock OverrideAuto Off Flame
AM
PM
20
Temperature Time
Clock Set
Timer 1 Set ON OFF
Timer 2 Set ON OFF
Using the
timers
After battery replacement the clock and timers may need to be re-programmed.
rinnai new Zealand Limited
The clock must be set before the timers will operate.
1. Press the Time Set button once, 'Clock Set' will be displayed to confirm
function is initiated. The remote will show 'AM 12:00'.
2. Use the up and down buttons to set AM or PM, then press the Time Set
button once to start programming the timers.
If you do not want to set the timers at this point, press Time Set four more
times until the display returns to the time. If no button is pressed within
approximately 90 seconds the screen will deactivate and any settings that
have not been transmitted will be lost.
After the clock has been set and the Time Set button selected:
1. 'Timer 1 Set ON' and 'AM 06:00' will be displayed. Use the up and down
buttons to set the desired AM or PM on time. Press the Time Set button
once.
2. 'Timer 1 Set OFF and 'AM 09:00' will be displayed. Use the up and down
buttons to set the desired AM or PM off time. Press the Time Set button
once.
3. To set up Timer 2, repeat above steps or press Time Set three times to
exit the timer programme.
4. The set On/Off timers will be displayed briefly to confirm settings. When
the programs have been received the remote display will revert to the
time mode.
You can view the timer settings by pressing the Timer 1 or Timer 2 buttons
while the heater is operating. The display will briefly show the status of
each timer, i.e. Timer 1 On, Timer 1 Off. If the current time is outside of the
programmed times the heater will go into standby mode and the LED will
glow green.
To turn the timers off, press the relevant timer button again. The heater will
return to standby mode. If there are no timers set the Timer indicator will
go out.
Arriva Operation and Installation Manual: 10343-E
13
05-10