Rinnai Arriva Operation And Installation Manual page 16

Care and Maintenance
Filters continued
1. Carefully slide the upper tab labelled 'TOP' (no hole) back into the upper
Putting back
filter strips
2. While holding the filter flush with the door, lower the filter until the
3. Close the room air return doors so the spring loaded latches lock in
Heater shut
•
down due to
filter blockages
•
When an obstructive build up is detected the blockage indicator Led which
is located above the receiver window will begin to flash red to let you know
there is a problem.
Once the indicator light is flashing, if no action is taken the heater will
eventually shut down to avoid overheating. An error code of 14 will be
displayed in the error display window on the top panel of the unit.
Returning the
To restore normal operation after a filter blockage:
appliance to
normal after a
1. Press the On/Off button once to turn off the heater.
shut down
2. Clean the filters as outlined in these instructions.
3. Press the On/Off button to turn the heater back on.
4. Use remote control to resume normal operation.
rinnai new Zealand Limited
retaining slot.
lower tab is in the lower retaining slot.
place.
Do not wait for the filter blockage indicator (error code 14) to come on
before cleaning the filters
Do not continue to use the heater once this indicator is flashing (red)
Arriva Operation and Installation Manual: 10343-E
16
05-10