Frymaster FM45E Installation & Operation Manual page 21

10. selp (Select Product) will again appear
in the left display. If more products are to
be programmed, return to Step 5 and fol-
low all instructions to this point, repeating
for each product.
11. When you complete your programming,
lock in the whole program by pressing the
Temperature Check/Program Lock switch
.
USING THE BOIL-OUT FEATURE
CAUTION
Before using this feature, ensure the
frypot is filled with a mixture of cold
water and Frymaster FRYER 'N'
GRIDDLE cleaner or detergent.
1. To program the fryer for boil-out, press the
Power switch
followed by the Program Mode switch
Code will appear in the left display.
2. Enter the code number 1653. The right
display will read boil boil boil boil. The temperature is
automatically set for 195ºF (91ºC). The
fryer will attain this temperature and re-
main there until the Power
ON ) switch is pressed, which cancels the
OFF
boil-out mode. In high-altitude locations,
the fryer must be monitored constantly for
boil-over conditions. If boil-over occurs,
turn off the fryer immediately, allow it to
cool, then re-enter the boil-out mode to
continue the boil-out process.
FRYER RECOVERY TIME CHECK FEATURE
"Recovery time" is the amount of time it takes
the fryer to increase the temperature from
275 ° F (135 ° C) to 325 ° F (163 ° C). It is a
measure of the fryer's efficiency. It should be
45 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
ON
(or ON/OFF switch)
OFF
(or ON/OFF
no more than 2 minutes and 30 seconds. If the
recovery time is greater, call your FASC.
1. To check recovery time, press the Program
Mode switch
the left display.
2. Enter the code number 1652 on the
number keypad. The recovery time will
appear in both displays for 5 seconds.
SELECTING FAHRENHEIT– CELSIUS DISPLAY
MODE
1. The computer can display temperatures in
either Fahrenheit or Celsius. To change
from one to the other, press the Program
Mode switch
the left display.
Enter the code number 1658 on the
2.
number keypad. The computer will toggle
the temperature display from Celsius to
.
Fahrenheit or from Fahrenheit to Celsius.
3. Press the Temperature Check/Program
Lock switch
in the newly selected mode.
SELECTING FRYPOT TEMPERATURE DISPLAY
MODE
1. To display the actual frypot temperature at
all times, press the Program Mode switch
. Code will appear in the left display.
2. Enter code 165L on both number key-
pads. The computer will display the actual
frypot temperature. NOTE:
product cooking process, the cooking time
will not be displayed, but timing is taking
place.
3. To return to setpoint display, repeat Steps
1 and 2.
3-7
. Code will appear in
. Code will appear in
to display the temperature
During the