Frymaster FM45E Installation & Operation Manual page 19

2. Press a product switch to initiate a cook
cycle.
a. The display will indicate the previ-
ously programmed cook time and be-
gin countdown.
b. If shake time is programmed, the op-
erator will be notified of the need to
shake the product "X" seconds after
the cook cycle has begun (X = amount
of time programmed). An alarm will
sound, and the display will read SH# # # # ,
where "#" will be the switch number.
If no shake time has been programmed,
sh# # # # will not appear during the cook
cycle. The alarm is self-canceling.
c. At the end of the cooking cycle, an
audible alarm will sound, cooc will
be displayed, and the associated prod-
uct switch indicator will flash.
cancel the cook alarm, press the ap-
propriate switch.
d. At this time, the hold time will be dis-
played (if programmed greater than
zero), and the countdown will begin.
When the countdown reaches zero,
hD_ hD_ will be displayed and an alarm hD_ hD_
will sound. The blank will be the
switch number. The hold alarm is can-
celed by pressing the Programming
switch . NOTE: If the display is in
use, the hold time countdown will not
be displayed.
3. To check the frypot temperature at any
time, press the Temperature Check switch
once. To check the setpoint, press the
switch twice. If you suspect the tempera-
ture probe is defective, check the tem-
perature of the frypot with a thermometer
or pyrometer to verify that the computer
45 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
To
readout is reasonably close to the meas-
ured reading.
4. During idle periods when the fryer is on
but not in use, "- - - -" should appear in
both displays.
temperature and setpoint.
The electronic circuitry in your
computer can be affected adversely by
current fluctuations and electrical
storms. Should it fail to function or
program properly for no apparent
reason, the computer should be reset
by unplugging the computer and
plugging it back in. This could prevent
a service call.
COMPUTER PROGRAMMING INSTRUCTIONS
1. Turn the computer on by pressing the
Power switch (or ON/OFF
2. Enter the programming mode by pressing
the Program Mode switch
appears in the left display. If you enter the
programming mode by mistake, press the
switch again to exit the programming
mode. NOTE: If you try to enter the pro-
gramming mode while the computer is
cooking, the display will flash busy
3. Enter the number 1650 by pressing the
number keys.
4. sp- - - - r (Setpoint) will appear in the left
display. Any previously programmed
temperature setpoint will appear in the
right display. To change the setpoint, en-
ter the desired setpoint temperature using
the number keys. For CE units, the highest
setpoint allowed is 370ºF (188ºC). For
Non-CE units the number is 375ºC
3-5
If not, check the actual
CAUTION
ON switch).
OFF
Code
.
busy. busy busy