Door Lock Harness (H2) Wire Connection Guide - Avital 2100 Installation Manual

H1/11 RED (+)12V constant power input
Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the constant
12V supply to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V power. Do not use the
15A fuse in the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE channel 2, (-) 200mA output
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-
torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other
high-current device will cause it to fail.

door lock harness (H2) wire connection guide

______
H2/1
______
H2/2
______
H2/3
This security system can control two common power door lock types without any additional parts! With
certain vehicles, or if an actuator is to be installed, either a 451M Door Lock Relay Satellite or two relays will
be required.
8
GREEN
OPEN
BLUE
(-) LOCK, (+) UNLOCK OUTPUT
UNLESS USING 451M
(+) LOCK, (-) UNLOCK OUTPUT
© 2001 Directed Electronics, Inc. Vista, CA