Installation - Lap Belt Only Without Top Tether - Baby Trend HYbrid 3-in-1 Owner's Manual

Toddler Car Seat
7.0
Harness) Installation and Use
7. Pull the vehicle Lap belt out and route
through the car seat using the "FRONT
ENTRY" belt routing as shown in Section
7.2 and buckle the vehicle seat belt.
8. Pull to check that the vehicle buckle
is securely locked.
NOTE: If Lap belt is not long enough
and LATCH system is not
available, install Car Seat using
"REAR ENTRY" belt path, (see
"Installation - Lap Belt Only
WITHOUT Top Tether" section).
9. Place knee inside seat and while pressing
down , pull on the free end of the vehicle
1
lap belt to tighten the lap belt around
2
the car seat.
10. Attach Top Tether Hook to vehicle tether
anchor and . Listen for the "click"
1 2
when the tether hook locks onto the
vehicle tether anchor.
11. Pull on the Top Tether Strap to check that
the Tether Hook is securely attached
12. Pull on free end of Top Tether Strap
until all slack is removed from the
Top Tether .
4
(With Built-in
Top
Tether
FRONT
ENTRY
Belt
Routing
2
1
2
.
3
3
Tether
Adjuster
39
Toddler Car Seat
7.0
Harness) Installation and Use
13. Check for a secure installation by grasping
the car seat armrest and pushing side-to-side
and front-to-back. The car seat should not
move more than 1 inch in either direction.
• If the car seat moves more than 1 inch,
retighten the vehicle seat belt and Top
Tether and test again.
• If the car seat moves less than 1 inch,
installation is complete. However if the
car seat still moves more than 1 inch,
try another seating position or see the
"Vehicle Seat Belts" section and check your vehicle
1
owner's manual for information on securing car seats.
To remove car seat:
1. Loosen Top Tether by pressing the button
on Tether Adjuster and sliding belt through
adjuster
2. Unhook Top Tether Hook for vehicle tether
4
anchor. Press up on retainer
Tether Hook
3. Unbuckle vehicle seat belt and remove
seat belt from belt path.
(With Built-in
.
1
, unhook
2
, and remove .
3 4
40
4
1
3
2