Baby Trend HYbrid 3-in-1 Owner's Manual page 25

Toddler Car Seat
7.0
Harness) Installation and Use
4. Place the car seat on the vehicle seat in
a seating location and centered between
the Lap/Shoulder belt anchorages (see
"Selecting a Vehicle Seating Location"
section).
5. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner's manual
for use with a car seat.
6. Pull the vehicle Lap/Shoulder belt out
and route through the car seat using the
"REAR ENTRY" belt routing as shown
in Section 7.2 and buckle the vehicle
seat belt.
7. Pull to check that the vehicle buckle is
securely locked.
8. For vehicles with switchable retractors,
pull the shoulder belt all the way out to
switch the retractor into the locking
retractor mode and release the shoulder
belt allowing it to retract.
9. Place knee inside seat and while pressing
down, pull on the vehicle shoulder belt just
above the vehicle buckle to tighten the
vehicle lap belt around the Car Seat.
(With Built-in
REAR
ENTRY
Belt
Routing
47
Toddler Car Seat
7.0
Harness) Installation and Use
10. While holding the lap belt tight, pull slack
out of shoulder belt and allow retractor
to tighten shoulder belt.
11. Check for a secure installation by grasping
the car seat armrest and pushing side-to-side
and front-to-back. The car seat should not
move more than 1 inch in either direction.
• If the car seat moves more than
1 inch, retighten the LATCH belt
and test again.
• If the car seat moves less than 1 inch,
installation is complete. However if the
car seat still moves more than 1 inch,
try another seating position or see the
"Vehicle Seat Belts" section and check
your vehicle owner's manual for
information on securing car seats.
To remove car seat:
1. Unbuckle vehicle seat belt and remove seat
belt from belt path.
(With Built-in
48