Baby Trend HYbrid 3-in-1 Owner's Manual page 23

Toddler Car Seat
7.0
Harness) Installation and Use
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child's shoulders (see
"Changing Harness Strap Height" section).
4. Route the LATCH lower anchor belt using
the "REAR ENTRY" belt routing as shown
in Section 7.2.
5. Place the car seat on the vehicle seat in
a seating location equipped with LATCH
and centered between the LATCH
anchorages (see "Selecting a Vehicle
Seating Location" section).
6. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner's manual
for use with a car seat.
7. Attach the LATCH connectors on the
Lower Anchor Belt to the vehicle LATCH
anchorages and . Listen for the "click"
1 2
when the connectors lock onto the vehicle
anchorage.
8. Pull to check that the
connectors are securely
attached .
3
(With Built-in
REAR
ENTRY
Belt
Routing
LATCH
Connector
43
Toddler Car Seat
7.0
Harness) Installation and Use
9. Place knee inside seat
1
down, pull on the free end of the LATCH
lower anchor belt to tighten the LATCH
lower anchor belt around the Car Seat
10. Check for a secure installation by grasping
the car seat armrest and pushing side-to-side
and front-to-back. The car seat should not
move more than 1 inch in either direction.
• If the car seat moves more than
1 inch, retighten the LATCH belt
and test again.
• If the car seat moves less than 1 inch,
installation is complete. However if the
car seat still moves more than 1 inch,
try another seating position or see the
"Vehicle Seat Belts" section and check
your vehicle owner's manual for
information on securing car seats.
(With Built-in
and while pressing
.
2
2
44
1