Forward Facing Installation With Lap/Shoulder Belt And Top Tether - Baby Trend CV88 Owner's Manual

Installation and Use
5.0
4. Route lap/shoulder belt through the rear
facing safety belt path (Fig. 25a).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing the
restraint to the vehicle.
5. Put weight in seat with hand to compress the
automobile seat cushion then insert the seat
buckle tongue into the buckle and pull seat
belt tight as possible (Fig. 25b). Pull up on
buckle as to ensure the buckle is secure.
6. Lower flap and secure hook and loop
fasteners and all snaps (Fig. 25c).
7. Ensure the angle indicator line is level with
the ground to keep the child's airway open
(Fig. 25d).
8. Check for movement of the restraint at the
safety belt path. The restraint should not
move more than 1 inch in any direction. If the
restraint moves more than 1 inch, repeat all
steps until all safety steps are met.
25
Fig. 25a
Fig. 25b
Fig. 25c
Fig. 25d
Copyright © 2015, Baby Trend, Inc.
5.5 Forward Facing Installation with Lap/shoulder Belt and
Top Tether
Requirements. See section 2.3:
Weight is 23 - 65 lbs (10.43 - 29 kg)
Height is 50 inches (127 cm) or less.
Age is 1 year old.
1. Place this restraint in a rear seating position. Always adjust the recline foot to
the upright position when forward facing.
2. Ensure vehicle is level and that the Convertible is placed flat, and rests on
the front outer edge of the vehicle seat.
3. Lift back flap and place harness to side.
Copyright © 2015, Baby Trend, Inc.
Installation and Use
5.0
Top Tether
26