Forward Facing Installation With Lap/Shoulder Belt And Top Tether - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use
4. Use body weight or apply weight in seat
with hand to compress the vehicle seat
cushion then insert the lower anchor
connector onto the vehicle anchor point
(Fig. 29a). Tighten the lower anchor
connector by pulling up on the webbing
end through opening in seat fabric
(Fig. 29b). Pull up on the lower anchor
connector to ensure the lower anchor is
securely fastened.
5. Ensure the angle indicator bubble is
centered between the lines for children
4-22 lbs. (1.81 - 9.97 kg) to keep the
child's airway open. Ensure the angle
indicator line is level with the ground for
children 23-40 lbs. (10.43 - 18.14 kg) to
keep the child's airway open (Fig. 29c).
6. Check for movement of the car seat
at the safety belt path. The car seat
should not move more than 1 inch in any
direction. If the car seat moves more
than 1 inch, repeat all steps until all
safety steps are met.
29
Fig. 29a
Fig. 29b
Fig. 29c
Center bubble for
children 4-22 lbs.
CV0107052419
Fig. 29d
Copyright © 2021, Baby Trend, Inc.
5.5 Forward Facing Installation with Lap/shoulder
Belt and Top Tether
See section 2.2 for requirements.
• Weight is 23 - 65 lbs (10.43 - 29.48 kg).
• Height is 50 inches (127 cm) or less.
• Age is 1 year old.
1. Place this car seat in a rear seating position. Always adjust the
recline foot to the upright position when forward facing.
2. Ensure vehicle is level and that the car seat is placed flat, and rests
on the front outer edge of the vehicle seat.
3. Loosen harness by pressing the center
adjuster and pulling on harness. Pull
top of seat fabric down to expose the
forward facing belt path (Fig. 30a).
NOTE: Remove any twist in webbing
to ensure the webbing lies for securing
the car seat to the vehicle.
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
Top Tether
Fig. 30a
30