Latch - Forward Facing Installation With Lower Anchor And Top Tether - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use
4. Route seat belt through forward facing
belt path (Fig. 33a).
5. Put weight in seat with hand to compress
the automobile seat cushion then insert
the buckle tongue into the buckle and
adjust seat belt as tight as possible
(Fig. 33b).
6. Pull seat fabric up and over the top of the
car seat. Then, install the pillow (Fig. 33c).
7. Pull up on buckle as to ensure the buckle
is secure.
8. Attach Top Tether to a designated anchor
point. Pull Top Tether strap until webbing
strap is snug (Fig. 33d).
NOTE: Your vehicle owner's manual will
give the anchor locations and maximum
weight of the car seat's occupant for LATCH
connections.
9. Check for movement of the car seat at the
safety belt path. The car seat should not
move more than 1 inch in any direction. If
the car seat moves more than 1 inch repeat
all steps until all safety steps are met.
33
Fig. 33a
Fig. 33b
Fig. 33c
Fig. 33d
Copyright © 2021, Baby Trend, Inc.
5.7 LATCH - Forward Facing Installation with Lower Anchor and
Top Tether
See section 2.2 for requirements.
• Weight is 23 - 55 lbs (10.43 - 24.9 kg).
• Height is 50 inches (127 cm) or less.
• Age is 1 year old.
DO NOT install by this method
for a child weighing more than 55
lbs. (24.9 kg.). DO NOT use the
lower anchors of the child restraint
anchorage system (LATCH system) to attach this child restraint when
restraining a child weighing more than 55 lbs (24.9 kg).
1. Place the car seat in a rear seating position. Always adjust the recline
foot to the upright position when forward facing.
2. Ensure vehicle is level and that the car seat is placed and rests on
the front outer edge of the vehicle seat.
3. Loosen harness by pressing the harness
adjuster and pulling on harness. Pull top
of seat fabric down to expose the forward
facing belt path (Fig. 34a).
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
Top Tether
Fig. 34a
34