Baby Trend HYbrid 3-in-1 Owner's Manual page 26

Toddler Car Seat
7.0
Harness) Installation and Use
7.4.3 Installation - Lap Belt Only
WARNING!
• Vehicle seat belt system MUST stay tightly adjusted to car
seat at all times. If vehicle seat belt does not stay tight, read
vehicle owner's manual and "Vehicle Seat Belts' section in
this manual.
To secure car seat in vehicle:
1. Assemble of the Back Support (see
"Assembly and Removal of Back
Support" section).
2. Store LATCH and Top Tether by
securing LATCH Connectors and
Tether Hook on LATCH/Tether Storage
Bar at bottom of Back Support as shown.
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child's shoulders (see
"Changing Harness Strap Height" section).
(With Built-in
WITHOUT Top Tether
LATCH Connectors
Top Tether
Tether/LATCH
Storage
49
Toddler Car Seat
7.0
Harness) Installation and Use
4. Place the car seat on the vehicle seat in
a seating location and centered between
the Lap belt anchorages (see "Selecting
a Vehicle Seating Location" section).
5. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner's manual
for use with a car seat.
6. Pull the vehicle lap belt out and route
through the car seat using the "REAR
ENTRY" belt routing as shown in
Section 7.2 and buckle the vehicle
seat belt.
7. Pull to check that the vehicle buckle is
securely locked.
8. Place knee inside seat and while pressing
down , pull on the free end of the vehicle
1
lap belt to tighten the lap belt around the
Car Seat .
2
(With Built-in
REAR
ENTRY
Belt
Routing
1
2
50