Table of Contents
Advertisement
Securing Car Seat in Your Vehicle
10.0
10.3.1 Initial Positioning
1. Follow instructions in Section 10.1 Preparation for
Installation in Vehicle.
2. Store LATCH Connectors in the storage location on
the side of the base (Fig 39-1).
3. If vehicle seat back is adjustable, adjust into the
upright position or the position or the position specified
in the vehicle owner's manual for use with a Car Seat.
4. Snap Car Seat into Base and place Car Seat and
Base onto the vehicle seat in the rear-facing position
in the vehicle seating location selected. Check for the
correct seat recline and adjust recline as necessary.
(Fig 39-2) See Section 11.4 Adjust Seat Recline
Angle.
5. Remove any toys or other objects attached to the
carry handle before installing car seat in vehicle.
6. Remove the Car Seat from the base by squeezing
the base release handle located under the center of
the foot end of the Car Seat and lifting upward on the
Car Seat. (Fig 39-3)
7. Place the Base in the rear-facing position in a forward
facing vehicle seat with Base contacting vehicle seat
back as shown in (Fig 39-4).
39-1
(10 kg) and
(10 to 14.5 kg)
39-2
39-3
39-4
39
Securing Car Seat in Your Vehicle
10.0
10.3.2 Secure Base WITH Vehicle
Combination Lap/Shoulder Belt
1. To secure base with Vehicle Combination Lap/
Shoulder Belt: open lock off, feed vehicle lap/
shoulder belt into the Vehicle Belt Path openings,
and buckle vehicle belt as shown. (Fig 40-1).
10.3.3 Secure Base WITH
Vehicle Lap Belt only
1. To secure attach Base with Vehicle Lap Belt only:
slide the vehicle lap belt into the Vehicle Belt Path
openings, and buckle vehicle belt as shown in (Fig
40-2).
10.3.4 Tightening Vehicle Seat Belt
1. Check that lap belt is not twisted.
2. Proper installation of the Base requires that the vehicle lap belt be very
tight and stay tight.
Lock off
release
40-1
Lock off
release
40-2
40
button
button
Hide quick links:
Advertisement
Table of Contents
