Oki OKIFAX 5750 Service Manual page 381

61 Remote Receive
62 T/F Timer Prg.
63 Continuous Tone
allowed if SERVICE BIT = ON).
* If DISTINCTIVE RING is settable, ON/OFF/DRC is selectable.
("Settable" means that SERVICE BIT is ON or mask by XPARA is not
provided with SERVICE BIT = OFF.)
* If DISTINCTIVE RING cannot be set, ON or OFF is selectable.
* Setting is possible if SERVICE BIT is ON even though masking is
done by XPARA. In this case, if SERVICE BIT is turned OFF with this
setting set to DRC, setting is changed from DRC to the default (i.e.
initial value provided for each default type).
* If COUNTRY CODE is USA, AUS, NZL, SIN, or HNG, this setting is
set to DRC. If COUNTRY CODE is changed to any other country,
setting is changed from DRC to the default.
Set a remote access address.
This function is used to transfer a call received by an external
telephone set (connected to fax) by entering two-digit MF tones if the
remote receive setting is not OFF.
When this function is off, control of Parallel Pick Up doesn't do it at all
regardless of ON/OFF of Parallel Pick Up setting.
1) Setting values
Select one of the following:
OFF/00/11/22/33/44/55/66/77/88/99/**/##
* Selection is skipped over when the ISDN board is mounted (selection
allowed if SERVICE BIT = ON).
Set the time till start of automatic reception when the operator has
performed no operation for the call terminated in the TEL/FAX mode.
1) Setting values
20SEC/35SEC selectable
* Selection is skipped over when the ISDN board is mounted
(selection allowed if SERVICE BIT = ON).
Set up the reception completion buzzer.
The buzzer sound can be stopped by pressing the STOP key.
1) Setting values